Angle Clip - Powder Actuated Pin with 1/4
Angle Clip - Threaded Rod RT 1/4-20 with 1/4
Angle Clip - Threaded Rod RT 1/4-20 with Powder Actuated Nail
Angle Clip - Threaded Rod Z with 1/4-20 Threaded Hole & 1/4
Angle Clip - Threaded Rod Z with Powder Actuated Nail & 1/4-20 Threaded Hole
Eye Lag Screw - 1/4
Eye Lag Screw - 2
Hanger - Angled Overhang 45º with 1/4
Hanger - Hammer On 1/8 Thru 1/4
Hanger - Hammer On 5/16 Thru 1/2
Installation Tool - Eye Lag Driver - Fits Into Any Drill, 1/4 HEX
Installation Tool - Vertical (JH901-100) and Angled Overhang (JH902-100)
Pressed Beam Clamp for 1/2
Threaded Rod - 1/4-20 Male Coupler with 1 1/2
Tips & Tricks
Listen To Your Stripper
Your Coax stripper!
Listen To Your Stripper — Your Coax stripper!
When stripping coax, do not turn your tool around as though it were a propeller.
As you rotate your tool, listen to the cutting of the braid and when it stops talking to you, turn another 1/8 to a 1/4 turn, open tool and remove the stripper. When rotating, be sure the hand that is holding the cable is supporting the cable immediately next to the tool. Allow no cable play!